.75 [19]
801 Avenida Acaso, Camarillo, Ca. 93012 • (805) 494-0622 • www.sdcsecurity.com • E-mail:
[email protected]
1.00 [25]
30-4 Frame Preparation Method of installation may vary per door, frame and lockset manufacturer. Left handed door installation shown.
4.13 [105]
.84 [21]
*
3.94 [100]
CL of Pullman Latch
.84 [21] .63 [16]
4.13 [105]
.12 [3]
*
2.00 [51]
CL of Cutout
CL
.41 [10]
Model 30-4 Electric Strike
3.89 [99] 2X 1/4-20 UNC
.50 [13]
CL of Keeper
1.74 [44]
9.00 [229]
.95 [24] .51 [13]
1.70 [43]
1.09 [28]
1.13 [29]
1.75 [44]
CL
Face of stop
Set Screw Locations
.33 [8] 1.34 [34]
.33 [8]
*
Dimensions are flipped for right handed door installations
Spacer Removal A 1/4” spacer plate is preinstalled to the strike faceplate. Removal of the spacer plate will decrease the faceplate thickness from .75" to .50". To remove spacer follow these steps: 1. Remove strike body from faceplate. 2. Remove four #8-32 screws and two #2-56 screws as shown on left. 3. Remove spacer. 4. Re-attach strike body to faceplate.
30-4 ELECTRIC STRIKE AND FRAME, PREP. TEMPLATE
Horizontal Adjustability #2-56
#8-32 NOTE: Not compatible with SDC 6000 series Rim Devices. Check Manufacturers exit device template for compatibility.
Faceplate
#1/4-20
1. Loosen the two #1/4-20 socket cap screws as shown to the right. 2. Adjust strike to appropriate horizontal position. 3. Tighten the two #1/4-20 socket cap screws. 4. Lock down adjustment by installing the provided set screws.
Spacer P:\INSTALLATION INST\Electric Strikes\Temp-30-4\TEMP-30-4.vsd
REV C
12-10
Page 1
Any suggestions or comments to this instruction or product are welcome. Please contact us through our website or email
[email protected]
TEMP-30-4
