DGS&D - QA
Inspection Report for Punched Tape Concertina Coil 610 mm dia
QA/GE/15(b)
(To be prepared separately for each lot / GSM inspected) QA Office File no. RC/Order no. Supplier Description of Stores
Drawing Nos
Punched Tape Concertina Coil IMPD-1817/B, IMPD-1820, DGS&D/GE-15/01, DGS&D/GE-15/02
Inspection Call No & date Quantity ordered Place of Inspection Quantity offered Quantity Inspected & Date of Inspection
Specifications CQAE/5660/1602/a Sampling as per CQAE/TS/1480/a Lot No. No. of samples drawn Source of steel Pre-inspection report □ Verify correctness as per supply □ contract (Tick √) Finish □ Freedom from defects □ Test Results Sample no. Parameter Requirement 1 1. COIL DIMENSIONS: a) Dia, of coil when closed610mm (+20mm&-0.00mm) b) Dia of coil when opened to 6 580mm (+20mm & -0.00mm) mtrs c) Wt of one coil 9.0 Kgs (+5% & -5%) 2.STEEL STRIP a) Width in mm b) Thickness in mm 3. SPRING STEEL CORE WIRE a) Grade of material b) Tensile strength (1620 N/SQ MM Min) c) Reduction in area 40 % minimum d) Torsion test (22 Turns MIN) e) Zinc coating test (230 gms/sq mtrs min) f) Normal dia. Uncoated wire 2.6mm(+/- 0.035mm) 4.DRAWING REQUIREMENTS a) Punched Tape i) Grade (Mat Finish) ii) Hardness 137-180 VPN iii) Local Coating (12 micron) iv) Average Coating (18 micron) vi) Chromate conversion coating b) Clip Steel grade ‘A’ as per IS:2062) i) Material (Steel grade ‘A’) ii) Dimensions iii) Finish Hot dip galvanized (20 micron or 290g/sq mtrs) iv) Bend Test 5. Performance Requirement Other parameters as per IS / RC
Markings □
Packing □
Identification Plate □
Workman ship □
2
3
4
5
Notes:* Use extra sheets if required * Number of specimen to be tested for each sample and test methods adopted for different tests and criterion of conformity shall be as specified in the governing spec/R/C. * Results on all specimens to be reported on separate sheets and only the final value as applicable shall be reported in the table above. * Values and tolerances of different parameters shall be in accordance with the contract and shall be noted in the first column. *All tests as per R.C spec shall be conducted. . *Where applicable raw material manufacturer test certificate as per relevant specification shall be obtained from the supplier.
Quantity accepted *
Quantity rejected
Packing details to be incorporated in I Note How I Mark put
Facsimile of I mark
Name, Designation and seal of supplier Date Place
Name, designation, seal of Inspector
