DRAWING / PROFORMA / ANNEXURE ATTACHED ( click on following to view print ) INSPECTION REPORT PERFORMA DGS&D-QA
Inspection Report for Thermocoat UNDER PANT- (Bleached)
Q.A. Office File No. R.C.NO. S.O. NO. NAME OF SUPPLIER
QA/TEX/2012
( to be prepared separately for each lot inspected ) Inspection Call No. & Date Qty. Ordered PLACE OF INSPECTION QTY. INSPECTED
DESCRIPTION OF STORES Thermocoat under Pants PACKING DETAILS ( ATTACH LIST GIVING SR. NO., SHADE, LENGTH & MASS LOT WISE ) SPECIFICATION BIS LICENCE NO. DATE & VALIDITY FOR ISI MARKED SEALED / APPROVED SAMPLE NO. & DATE LOT NO. SAMPLES TO BE SELECTED AS PER CLAUSE- ….. …..OF SPECIFICATION VERIFY PRE INSPECTION BIS LICENCE MARKINGS CORRECTNESS AS PER REPORT CONTRACT ( TICK ) FEEL AND FINISH SELVEDGE TYPE OF PACKING
SL. NO.
PARAMETERS
REQUIREME NT
Tolera nce
1
Blend Composition ( leg )
80 % cotton & 20% polyester 97 % cotton & 3 % spandex
±5%
TEST RESULTS 1
2
SHADE AS PER SAMPLE
2
3
4
5
Blend Composition ±1% (bottom ) 3 Body A No of Wales/Inch 32 ±2% B No. of Cource/Inch 30 ±2% 4 Bottom A No of Wales/Inch 54 ±2% B No. of Cource/Inch 42 ±2% 5 Dimensional Change in % A Length wise 2.5 Max B Breath wise 2.5 Max 6 pH 6 to 8 7 Scouring Loss 2.0 Max 8 Mass/sq. mtrs. In gms. 200 ±5% NOTES:- ANY OTHER REQUIREMENT / TEST AS PER IS: / R.C./ G/TEX/C-140/2010 USE EXTRA SHEETS IF REQUIRED, ALL PARAMETERS AS PER IS: / R.C. SHALL BE TESTED, NUMBER OF SPECIMEN TO BE TESTED FOR EACH SAMPLE AND TEST METHODS ADOPTED FOR DIFFERENT TESTS, VALUES AND TOLERENCES OF DIFFERENT PARAMETERS AND CRITERIA FOR CONFORMITY SHALL BE AS SPECIFIED IN THE IS:, RESULTS ON ALL SPECIMENS TO BE REPORTED ON SEPARATE SHEETS AND ONLY THE FINAL VALUES AS APPLICABLE SHALL BE REPORTED IN THE TABLE ABOVE. EXTRA SHEET ATTACHED AS ABOVE. CONCLUSION: QTY. ACCEPTED QTY. REJECTED. PACKING DETAILS TO BE INCORPORATED IN I.NOTES HOW I. MARK FACSIMILE OF NAME, DESIGNATION, SEAL PUT I.MARK OF INSPECTOR NAME, DESIGNATION AND SEAL OF SUPPLIER DATE
